A new type of PDA device which is similar to BlueBird device but less expensive.

How to install?

You can install and setup the device exactly same as Bluebird device:

How do I install a new Bluebird access control device?

How do I set up my Bluebird access control device?

Next step we need to config DataWedge on the phone:

Configure DataWedge to output scans via intent:

1. Launch the DataWedge via Apps > DataWedge.

2. Edit the Profile0 (default) .... (delete all the exist profile if needed)

3. Confirm the following settings:

• The profile is enabled
• Barcode input is enabled
• Intent output is enabled

On TC26 there will be a check box Hardware Trigger make sure to check this

Configure the intent output as follows (VERY IMPORTANT!!!):

• Intent action: com.secutix.accesscontrol 
• Intent category: (leave blank)
• Intent delivery: Broadcast intent

Then continue with the step in: How do I set up my Bluebird access control device?

At the step to configure the device, you will see the option to choose Scan Type, Choose Zebra Scanner and perform the scan like normal.

Note: 

If the device is being used for Wifi only, or a SIM card is not installed yet, this message (see screengrab) regularly pops up, which is quite annoying:

This is easily fixed by (a) Putting device in Airplane mode and (b) Turning Wifi on. Using these two steps the prompt disappears.